This Haunted House Trick or Treat Box is easy to stamp and put together. Add Treats for your special Trick or Treaters.
SUPPLIES:
Bundle: Tricks & Treats stamps + dies
Ink Pad: Memento Tuxedo Black
Cardstock: Pumpkin Pie cardstock
Adhesive: Tear & Tape
INSTRUCTIONS:
This Video is less than 9 minutes.
The Video above talks about different papers you can use, die cutting, adding your Tear & Tape, and putting the box together. It was much easier to show you than to describe how to do it.
1-Cut Your Paper:
~5-1/2″ x 11″ Pumpkin Pie cardstock.
~Die Cut Two Box pieces.
2-Stamp:
~Choose your Stamps and lay them on the large Front or Back section.
~Stamp with Memento Black ink.
~You can stamp both the Front and the Back the same if you want or change it up.
NOTE: If desired you can put all the stamps on one block to stamp. Make sure your ink pad is well inked so you will get a great stamped image the first time. I cheated and used my retired Stamparatus.
3-Put Your Box Together:
~Add your Tear & Tape as shown in the video and the photo.
~Fold all Score Lines and crease with your Bone Folder.
~Lay your Box Die Cuts as shown.
~Place Tear & Tape as shown on Template.
~Remove the Tear & Tape backing from the Front Small Side Flap.
~Attach Back Outside Large Side Flap on top of Front Small Side Flap. Line up the cardstock edge with the Score Line. Attach.
~Turn over so the Inside is on top.
~Fold in half at the Front Small Flap Score Line.
~Remove Tape Backing from the Back Small Side Flap and attach to the Front Large Side Flap.
~Remove the Tape Backing from the Back and Side Flaps.
~Fold in the Side Flaps first, then the Bottom Back Flap, and then the Bottom Front Flap.
Your Haunted House Trick or Treat Box is ready for Treats.
