This Happy Halloween Treat Box is quick and easy to make for those special Trick or Treaters. It uses the “Them Bones” Designer Series Paper and the Tricks & Treats Dies.
SUPPLIES:
Cardstock: Them Bones 12×12 Designer Series Paper (DSP)
Stampin’ Write Marker: Basic Black (I used Orchid Oasis)
Stampin’ Cut & Emboss Machine: Tricks & Treats Dies
Tool: Paper Snips or your favorite fussy cutting scissors
Adhesives: Tear & Tape
Black Stampin’ Dimensionals
INSTRUCTIONS:
This video is less than 9 minutes long.
1-Cut:
~DSP Print: 5-1/2″ x 12″. The 12″ side should be the top & bottom of the pattern as shown in the video.
~Fussy Cut out a Skeleton from one of the DSP sheets.
2-Decorate:
~Lay your Skeleton where you want it on the front..
~Write or stamp “Happy Halloween. I hand wrote “Happy Halloween” because I don’t have the size of Words I want. I need to get a new Basic Black Marker…
3-Tear & Tape:
Put Teat & Tape on as shown in the video:
Outside Print:
~Small Side Flaps along the Score Line
~Small Bottom Flaps on the edge
~Large Bottom Flap-Back section: On the edge
Inside Print:
~Large Bottom Flap of Front section: on the edge
4-Assemble Your Box:
Watch The Video to see how to put your Box together.
~Attach one Small Side Flap to the other piece’s Large Side Flap as shown in the video. It might be easier to line up on the DSP side with the least busy print.
~Fold over to attach the second Small Flap to the second Large Flap to make your Box a Rectangle.
~Fold up the Flaps to see where they go.
~Remove Tear and Tape backing from all the Bottom Flaps EXCEPT the Large Front Flap.
~Fold in the Small Side Flaps first, then then Back Bottom Flap. Remove the Tear & Tape backing from the Front Flap and fold it over.
~Use your Bone Folder to rub the bottom Flaps and make sure the adhesive sticks well.
Fill your Happy Halloween Treat Box with Treats and you are ready for Halloween!
