This Christmas Double-Ribbon Card uses two different colored ribbons as a focal point. The Tag is layered with a simple mat using the same punch.
SUPPLIES:
Stamps: Hope & Peace #159773
Ink Pad: Real Red #147084
Cardstock: Basic White #159276
Real Red #102482
Boughs of Holly 12×12 Designer Series Paper (DSP) Sold out.
Punch: Label Me Fancy #151297
Ribbon: Real Red & Garden Green 3/8″ Ribbon Combo Pack #159577
Adhesives: Tombow Multipurpose Liquid Glue #110755
Tear & Tape #154031
Stampin’ Dimensionals #104430
INSTRUCTIONS:
1-Cut Your Papers:
~Real Red Card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″.
~DSP Print: 4″ x 5-1/4″
~Optional Card Insert: 4″ x 5-1/4″. Stamp or decorate if desired. Attach inside your Card Base.
2-Ribbons:
NOTE: I would recommend you lay your DSP on Grid Paper. OR… Measure and make a pencil mark on your DSP so you get the Tape and Ribbon straight.
~Decide where you want your Ribbons. My Green one is about 1″ from the bottom edge of the DSP.
~Put a strip of Tear & Tape on the top of your DSP where you want your Green Ribbon to go.
~Wrap your Ribbon around the back of your DSP and attach to the Right Side of your DSP only attaching about 1-1/2″ from the side. Make sure you have 4-6″ of Ribbon hanging loose from where you attached it.
~Attach the other part of your Ribbon wrapping it around the front and on top of the Tear & Tape. Have it meet where the other side left off. Leave 4-6″ of ribbon hanging loose.
~Add a piece of Tear & Tape for your Red Ribbon.
~Repeat with your Red Ribbon meeting where your Green Ribbon met.
~Tie a knot with both pieces of ribbon together. Trim the ends. Spread the Ribbon ends apart.
~Glue your DSP & Ribbons to your Card Base.
3-Tag:
~Stamp your Words on Basic White cardstock. Punch out.
~Punch your Real Red cardstock twice to get two Red Tags.
~Cut one Real Red Tag in half the long way, and the other in half the short way.
~Spread Glue on the back of your White Stamped Tag.
~Add a Short cut Tag to each end with about 1/8″ sticking out from your Stamped Tag.
~Repeat with your Long ways Tag pieces with them sticking out about 1/8″ from your White Tag.
~Add Stampin’ Dimensionals and attach to your Card.
Your Christmas Double-Ribbon Card is finished.
