Making a Diagonal Strips Card Front is pretty easy. Just determine your angle and cut. Watch the video below to see how easy it is.
This Video is 13-1/4 minutes long.
SUPPLIES:
Paper Trimmer #152392
Whale of a Time 6×6 Designer Series Paper (DSP) #152460
Bermuda Bay cardstock
Coastal Cabana cardstock
Whisper White cardstock
Bermuda Bay ink pad
Stampin’ Seal
Paper Snips
Silicone Craft Sheet #127853
Good Morning Magnolia stamps #149298
Rectangular Postage Stamp Punch #152709
TIPS:
Check out the Original Card Design HERE.
Cut your card front. Mine is 4-1/4″ x 5-1/2″. You will be cutting it smaller later.
Determine which line on your Paper Trimmer to line up the corners of your paper with.
Decide how wide to cut your strips. I chose 1″ strips. Lay each strip on your card front in the order you cut them.
Lay them on your Silicone Craft Sheet. Put Stampin’ Seal on the back of your strip and line it up. I always line the first few up with the bottom of my card front. Then I line up the paper design.
Trim the excess DSP off the edges.
Cut away enough so you card front has no blank spots where the DSP was not long enough.
Your Diagonal Strips Card Front is finished.
Attach to your card base and finish your card. I used the Good Morning Magnolia stamp set and Rectangular Postage Stamp Punch.
