Kiev made this card for the Three Things #9 Challenge. I really enjoy all the bright colors she used. I am sure going to miss her as she graduates from High School on Thursday. She will then be off on a service adventure for two months, then off to college in another town.
SUPPLIES:
NOTE: These stamps and dies will be available in the 2019-2020 Annual Catalog except the stamps will only be available in Cling-Mount after June 4th. When supplies run out of Wood and Clear Mount you will get the NEW Cling Mount.
Stamps: Tropical Chic Wood-Mount #146750. Clear-Mount #146753, Cling-Mount #148226
Ink: Call Me Clover
Cardstock: Whisper White
Pacific Point
Poppy Parade
Call Me Clover
Lemon Lime Twist
Big Shot: Tropical Thinlits #146831
Rectangle Stitched Framelits #148551
Punch: Butterfly Duet #148523
Adhesives: Tombow Multipurpose Liquid Glue
Stampin’ Dimensionals
Mini Stampin’ Dimensionals
INSTRUCTIONS:
1. Cut your Pacific Point card base at 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″. Watch This Video for instructions on making Basic Card Bases.
2. Cut your Pacific Point card front at 4-1/4″ x 5″. Die cut the square leaves leaving about 1″ on 3 sides.
3. Lay your card front even with the left side of your card base. Stamp the Lines in Call Me Clover ink over both the card front and the card base. Notice they are uneven.
~Attach your card front to your card base with both regular and Mini Stampin’ Dimensionals. Cut in half if necessary to fit behind the thin leaves.
4. Die Cut:
Call Me Clover cardstock:
~Long Leaf Framelit
~Smaller Leaf-both parts
~Larger Leaf-both parts
Lemon Lime Twist cardstock:
~Long Leaf center
~Smaller Leaf-outside
~Larger Leaf-center
5. Punch your Butterflies from Poppy Parade using the Butterfly Duet Punch.
6. Stamp your words on Whisper White cardstock with Call Me Clover ink. Cut out with the coordinating Rectangle Stitched die.
7. Put your card together.
~Lay out all your pieces where you want them on the card front.
~Use Stampin’ Dimensionals to attach your words to your card base.
~Glue the leaves in place starting with the bottom layer and overlapping as desired.
~The small Butterflies are attached with Mini Stampin’ Dimensionals.
~Your large Butterfly has the left wing glued to your card base with a Stampin’ Dimensional under the right wing.
Your Card is finished!
Check out the “Categories” link on the sidebar to find more challenges including more Three Things Challenges. Now make your own Three Things Challenge using the specified items.
