This Shimmery Golden Merry Christmas Tree Card has a Gold Foil punched Christmas Tree and Shimmery Ribbon. You can use any patterned paper you want.
SUPPLIES:
Stamps: Poinsettia Petals #158251
Ink Pad: VersaMark #102283
Cardstock: Cherry Cobbler
Shaded Spruce
Gold Foil #132622
Tidings of Christmas 6×6 Designer Series Paper #155718
Stampin’ Cut & Emboss Machine: Stitched So Sweetly Dies #151690
Punch: Pine Tree #149521
Ribbon: Cherry Cobbler & Gold 1/2” Metallic #156312
Heat Embossing: Metallics Embossing Powders #155555
Heat Tool #129053
Adhesives: Stampin’ Seal
Stampin’ Dimensionals
Mini Stampin’ Dimensionals
INSTRUCTIONS:
1-Cut Your Papers:
~Cherry Cobbler Card Base: 5-1/2” x 8-1/2”. Score and fold at 4-1/4”.
~Shaded Spruce Card Layer: 2” x 5-1/2”
~Tree DSP: 2-1/4” x 6”
2-Tree Label:
~Use the largest Stitched So Sweetly Die to cut out the Green Pattern DSP AND a Shaded Spruce layer. Attach the DSP to the Shaded Spruce layer.
~Punch your Tree from Gold Foil.
~Put Stampin’ Dimensionals on the back of both the Tree and the Label. I cut a piece from the side of the Mini Stampin’ Dimensionals to put under the Tree Trunk.
3-Card Layer:
~Attach your Tree DSP to your Shaded Spruce Card Layer. Trim off the excess DSP.
~Put a strip of Stampin’ Seal down the center of these layers. Lay your Ribbon on top of the Stampin’ Seal strip and wrap it around these layers so the sides meet about 1-1/2” from the right side. Leave about 3” on each side to tie your knot.
~Tie knot and trim the ribbon ends.
4-Finish Your Card:
~Lay out your Card Layer and Tree Label on your Card Base to determine where to stamp.
~Stamp Merry Christmas with VersaMark in in the lower right.
~Cover with Gold Embossing Powder. Put excess back in the jar. Melt your Embossing Powder until shiny.
~Attach your Card Layer with Stampin’ Seal and your Tree Label with Stampin’ Dimensionals.
Your Shimmery Golden Merry Christmas Tree Card is finished.
