Quick Halloween Candy Holder

Make this Quick Halloween Candy Holder using any Halloween like patterned paper. I also used two punches, some ribbon, and let’s not forget the candy! I will give you the formula so you can make Candy Holders for any size candy. The supplies I used are listed below. Use your Paper Stash.

This Video is less than 8 minutes long.

SUPPLIES USED IN THE VIDEO:

Stamps: September Paper Pumpkin stamps
Ink Pad: Memento Tuxedo Black #132708
Cardstock: Pumpkin Pie #105117
Gingham Cottage 12×12 Designer Series Paper (DSP) #159651
Punches: Label Me Lovely #151290
Very Best Trio #159878
1/4″ Hand Held Circle Punch from your Local Store
Adhesives: Glue Dots #103683
Candy: Reese’s Peanut Butter Pumpkins from your local store OR other Fun Size Candy

INSTRUCTIONS:

Quick Halloween Candy Holder

1-Figure out your Paper Size:
~Get your Candy. Are you going to include more than one piece in your Candy Holder?
~Measure the candy your are putting in. Add 1/4″ to 1/2″ to the sides. This is how wide to cut your paper.
~Lay one or two candies in the center of the paper.
~Fold the paper in half with 3/4″ to 1″ of paper above your candies on both sides of the paper.

2-Finish Your Candy Holder:
~Now is the time to punch the upper corners if you want to.
~You can also punch your Two Ribbon Holes with the 1/4″ Circle Punch through both paper layers about 1/2″ from the top towards the center. Hopefully, your holes are straighter than mine were. 😉
~Put two Glue Dots on the back of each candy and put it onto your paper where you want it.
~Put your Ribbon through the Holes and tie a bow.

~Stamp your Words with Memento Black ink on Pumpkin Pie cardstock.
~Punch out.
~Attach to your Candy Holder with Stampin’ Dimensionals.

Your Quick Halloween Candy Holder is finished and ready to give.

Spread the love
Tagged , , . Bookmark the permalink.

Comments are closed.