This Pink Flower and Stripes Card uses two sheets of double-sided patterned paper to make the stripes. Add a die cut Flower and some Words to complete the focal point.
SUPPLIES:
Stamps: Crafting With You Stamps (also has coordinating Dies)
Bright Borders Stamps
Ink Pad: Berry Burst ink pad
Cardstock: Berry Burst cardstock
Basic White cardstock
Bubble Bath cardstock
2024-2026 In Color 6×6 Designer Series Paper
Stampin’ Cut & Emboss Machine: Hooray for Surprises Dies (also has coordinating Stamps)
Tools: Paper Snips Scissors
Adhesives: Tombow Multipurpose Liquid Glue
Tear & Tape
Stampin’ Dimensionals
INSTRUCTIONS:
1-Cut Your Papers:
~Bubble Bath Card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″
~Basic White Card Front: 3-1/2″ x 4-3/4″
~Berry Burst Layer: 3-5/8″ x 3-7/8″
~DSP Prints: 1-1/2″ x 6″. Cut into three 1/2″ x 6″ strips
2-Card Front Strips:
~Your DSP Strips will be at a diagonal. Measure from the bottom Left: 2-1/4″. From the bottom Right: 3-1/2″.
~Put Tear & Tape between these two marks and around the lower sides and bottom. Add another strip of Tape in the center of this area.
~Lay out your DSP Strips in the pattern you want.
~Attach to your Tear & Tape starting at the top of the Tape. Make sure the cardstock is completely covered. We will trim off the excess later.
~Attach your Strips until the lower part of your Card Front is covered. There may be a small area not covered yet.
~Turn your Card Front over so you can only see the part of the Strips sticking out.
~Trim off the Strips with your Paper Snips scissors that are hanging over the edge.
~Use the scraps to cover any White left on your Card Front and trim off the excess.
3-Flower:
~Cut one or two Flowers from Bubble Bath cardstock.
~Use Berry Burst cardstock to die cut the Flower Center.
~Layer the Flower pieces how you want them and glue together.
~Glue your Flower Center to the middle of your Flower.
~Put Stampin’ Dimensionals on the back of your Flower.
4-Finish Your Card:
~Stamp Small Flowers with Berry Burst ink part way on the Right Side and Bottom of your Card.
~Lay your Flower and Word Stamp on your Card Front to decide where you Stamp your Words.
~Use Berry Burst ink to stamp your Words on your Card Front above your DSP Strips.
~Attach your Flower to your Card Front with Stampin’ Dimensionals.
~Glue your Card Front to your Berry Burst Layer. Glue to your Card Base.
Your Pink Flower and Stripes Card is finished.
