Have you wondered How to Use Stampin’ Seal? Have you had problems when using it with the Tape Runner coming out of the case? Watch this Video to learn the simple technique to easily use your Stampin’ Seal. It is a great adhesive. It just has a slight learning curve which you can learn in less than 10 minutes!
This Video is almost 8-1/2 minutes long.
BASIC SUPPLIES:
Stampin’ Seal #152813
Silicone Craft Sheet #127853
ADDITIONAL CARD SUPPLIES:
Stamps: Happy Thoughts #154507
Ink Pad: Just Jade
Cardstock: Magenta Madness
So Saffron
Flowers for Every Season 6×6 Designer Series Paper (DSP) #152486
Punch: Everyday Label #144668
Ribbon: Just Jade Ribbon #153621
TIPS:
~Remember the angle is important!
~Apply it with your hand close to your cardstock but angled slightly up.
~When you are done tilt the whole case straight up and quickly slide to the side. This will keep the tape on your tape runner ready to use.
Card Details & Instructions:
Cut Your Papers:
~Magenta Madness Card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″.
~DSP: 4″ x 5-1/4″
Ribbon:
~Run your Tape on your DSP where you want your Ribbon to be. I am guessing I used about 22-24″ of ribbon for this card.
~Lay your DSP on top of the ribbon and lay the ribbon along the tape with the pieces meeting where you want to tie your bow. Tie your Bow.
Attach Your DSP to your Card Base:
~Remember the angle when applying the tape and at the end tilt your case straight up and quickly slide to the side.
Label:
~Stamp your Words with Just Jade ink on So Saffron cardstock. Remember to stamp “Straight Down, Straight Up” with no rocking or wiggling your stamp.
~Punch out your Words.
~Put Stampin’ Dimensionals on the back of your Label and attach it to your card.
Your Card is finished and you now know How to Use Stampin’ Seal.
