This Cute Batty Haunted House & Ghost Halloween Card uses the Tricks & Treats Bundle and the Them Bones Designer Series Paper.
SUPPLIES:
Bundle: Tricks & Treats stamps + dies
Ink Pads: Memento Tuxedo Black ink pad
VersaMark ink pad
Cardstock: Basic White cardstock
Basic Black cardstock
Pumpkin Pie cardstock
Very Vanilla cardstock
Lemon Lolly cardstock
Them Bones 12×12 Designer Series Paper
Stampin’ Cut & Emboss Machine: Trick & Treats Dies (part of the Bundle above)
Deckled Rectangles Dies
Stripes & Splatters 3D Embossing Folders
Heat Embossing: Basics Embossing Powders
Heat Tool
Ribbon: Black & White 1/4″ Gingham Ribbon
Adhesives: Tombow Multipurpose Liquid Glue
Stampin’ Dimensionals
Glue Dots
Tear & Tape
INSTRUCTIONS:
1-Cut Your Papers:
~Pumpkin Pie Card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″.
~Basic Black Card Layer: 4-1/8″ x 5-3/8″
~DSP Print: 4″ x 5-1/4″
2-Haunted House:
~Stamp your Haunted House with Memento Black ink on Lemon Lolly cardstock.
~Cut out your Haunted House with the coordinating Die.
~Cut out Your BOO from Basic Black cardstock.
~Trim excess off around the edges if the Lemon Lolly around the edges of your House is uneven like mine was.
3-Very Vanilla Layer:
~Choose the size of Deckled Rectangle Die you want. My cut image is 1-3/4″ x 3-1/4″.
~Cut your Deckled Rectangle from Very Vanilla cardstock.
~Lay your Haunted House, Boo, and your Gravestones stamp where you want them on the die cut.
~Stamp your Gravestones with Memento Black ink.
4-Finish Your Deckled Layer:
~Emboss with the Splatters 3D Embossing Folder.
~Attach your Haunted House with Stampin’ Dimensionals. Only put Dimensionals where it will touch the Very Vanilla cardstock.
~Glue on your BOO
~Add Stampin’ Dimensionals to the back of your Very Vanilla Layer.
5-Ghost:
~Stamp your Ghost with VersaMark ink on Basic White cardstock
~Cover with White Embossing Powder. Put excess Embossing Powder back in the jar.
~Melt with your Heat Tool on the High setting.
~Set aside. It is small and easy to lose.
6-Card Front:
~Decide where you want your Ribbon on your DSP Print. Mine is about 5/8″ from the bottom.
~Attach your 6-1/2″ length of Ribbon with Tear & Tape. Put the Tear & Tape on the DSP Print OR on the back of the Ribbon. Wrap the excess Ribbon around the back and attach.
~Add your Haunted House Layer with Stampin’ Dimensionals.
7-Finish Your Card:
~Glue your DSP Card Front to your Basic Black Layer.
~Attach these layers to your Pumpkin Pie Card Base.
~Tie a Bow and attach it with a Glue Dot.
~Fussy cut your Ghost. I found looking at the image on the Stamp Case helpful. Attach with a Stampin’ Dimensional.
Your Cute Batty Haunted House & Ghost Halloween Card is finished.
