Halloween Trick or Treat Bats Candy Holder Video

This Halloween Trick or Treat Bats Candy Holder is quick to make multiples of. You can get Five from a half sheet of cardstock and 10 from a whole sheet of cardstock. Each Candy Holder will hold two Hershey Miniature Candy Bars.

This Video is about 4 minutes long.

SUPPLIES:

Hershey Miniature Candy Bars
Stamps: Little Delights #156527
Ink Pad: Memento Tuxedo Black
Cardstock: Mango Melody
Adhesive: Glue Dots

Halloween Trick or Treat Bats Candy Holder

INSTRUCTIONS:

1-Cut and Score You Paper:
~For One Candy Holder: 1-1/2″ x 5-1/2″ cardstock. Score and fold at 2-3/4″
~For Five Candy Holders: 5-1/2″ x 8-1/2″ cardstock. Score along the 8-1/2″ side at 2-3/4″. Cut at 1-1/2″, 3″, 4-1/2″, 6″, 7-1/2″. Fold each one in half on the score line.
~For Ten Candy Holders: 8-1/2″ x 11″ cardstock. Score at 2-3/4″ from each 8-1/2″ side. Cut at 5-1/2 to get a half sheet. Then cut both sides at 1-1/2″, 3″, 4-1/2″, 6″, 7-1/2″.

The Templates below are for an 8-1/2″ x 11″ sheet of cardstock. It was just easier to type everything on two pictures even though you do all the cutting and scoring on one sheet of cardstock.

Halloween Trick or Treat Bats Candy Holder Template
Template Page one
Halloween Trick or Treat Bats Candy Holder Template

2-Stamp with Memento Black ink:
~Lay your stamps where you want them on the Candy Holder. Ink up and stamp.

3-Add Candy:
~Put a Glue Dot on the center back of each Hershey Miniature.
~Place inside cardstock. I got thinking that maybe if you have the sides of the candy bar overlapping, then the candy would be straighter inside.
~Put a Glue Dot at the top corner of one side and line up the other side and close.
Your Halloween Trick or Treat Bats Candy Holder is finished.

Spread the love
Bookmark the permalink.

Comments are closed.