Curvy Merry Christmas Trees Card

We are making this Curvy Merry Christmas Trees Card at my class next week. Wish you could join us!

SUPPLIES:

NOTE: Buy the Quite Curvy Variety Bundle which contains the Quite Curvy stamps + Curvy Dies + Curvy Christmas stamps + Classic Christmas DSP and save.

Stamps: Curvy Christmas #155364 (part of Variety Bundle)
Ink Pad: Real Red
Cardstock: Whisper White
Shaded Spruce
Classic Christmas 6×6 Designer Series Paper #155969 (part of Variety Bundle)
Stampin’ Cut & Emboss Machine: Curvy Dies (part of Variety Bundle)
Evergreen Forest 3D Embossing Folder #153576
Punch: Pine Tree #149521
Embellishments: Snowflake Sequins #150443 OR Adhesive Backed Snowflakes #153545
Adhesives: Tombow Multipurpose Liquid Glue
Stampin’ Dimensionals
Glue Dots (optional if using Snowflake Sequins)

INSTRUCTIONS:

Cut Your Papers:
~Whisper White card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″.
~Red Dotted DSP: 2-1/2″ x 5-1/2″ (You can cut this after your Curvy Layers are cut if you want.

Stampin’ Cut & Emboss Machine:

You will need to decide what angles you want your lower two Curvy layers. I found it easier to have the cardstock and DSP 6″ wide so I could adjust the angles on the card base and trim off the excess from the sides. Experiment with the Curvy Layers angles to get different looks.
~Use the Curvy Die with the Dots. Make sure the cutting edge is on the top of where you want to cut so the Dots will show up.
Green Tree Pattern:
~Left edge: 2-1/4″ high
~Highest point: 2-1/2″ high
~Right edge: 1-1/2″ high
Whisper White:
~Left center: 2-1/2″ high
~Right edge: 3-1/4″ high
~about 3-3/4″ shows

Pine Trees:
~Punch 3 Shaded Spruce Pine Trees.
~Line them up with the Tree Tops in the Evergreen Forest embossing folder.
~Run through your Stampin’ Cut and Emboss Machine with the #1 and #4 Plates.

Finish Your Card:

~Lay your pieces on your card base to decide where you want them.
~Glue all the pieces in the order below on except the lowest Pine Tree which is attached with Stampin’ Dimensionals.
~Red Snowflake DSP
~Pine Tree that is behind the Whisper White Curvy Layer
~Whisper White Curvy Layer
~Green Curvy Layer
~Stamp Merry Christmas on the White Curvy Layer with Real Red ink.
~Center Tree
~Left Tree with Stampin’ Dimensionals
~Add your Snowflakes. If using the Adhesive Backed Snowflakes – just peel and stick. If using the Snowflake Sequins: attach with either a drop of Tombow Glue or a Glue Dot. The Glue Dots are a little big so squish them to fit so you card front does not stick to everything.
Your Curvy Merry Christmas Trees Card is finished.