This Beautiful Hearts and Bows Valentine Card is pretty easy to make. Just die cut three Hearts and tie two bows to make this card to give to someone. You could replace the Hearts with other images to use this card layout all year long.
SUPPLIES:
Stamps: Sweet Conversations #157618 (also part of a Die Bundle)
Ink Pad: Real Red
Cardstock: Real Red
Basic White
Sweet Talk 12×12 Designer Series Paper (DSP) #157616
Stampin’ Cut & Emboss Machine: Bouquet of Love Hybrid Embossing Folder + Dies #157641 (also part of a Bundle)
Embellishments: Iridescent Rhinestones Basic Jewels #158130
Real Red 3/8″ Faux Linen Ribbon #158129
Adhesives: Stampin’ Seal
Stampin’ Dimensionals
Glue Dots
INSTRUCTIONS:
1-Cut Your Papers:
~Real Red Card Base: 5-1/2″ x 8-1/2″. Score and fold at 4-1/4″
~DSP Card Layer: 4″ x 5-1/4″
~Real Red Strip Layer: 2-1/4″ x 5-1/4″
~DSP Strip Layer: 2″ x 5-1/4″
2-Stamp & Die Cut:
~Stamp your Words on Basic White cardstock with Real Red ink. Cut out with the Long Label Die.
~Hearts: Cut two Real Red and one from DSP using the Small Heart Die. Sponge around the DSP Heart with Real Red ink if desired so it is easier to distinguish from the DSP Strip Layer.
3-Finish Your Card:
~Add your DSP Layer to your Card Base.
~Attach your DSP Strip Layer to your Real Red Strip Layer.
~Cut two 3″ pieces of Ribbon and tie a knot in the center of each.
~Put Stampin’ Dimensionals on the back of your Hearts.
~Lay your Hearts and your Ribbon Knots on your Strip. Lay the top and bottom Hearts about 1/4″ from the top and bottom edge. Place the DSP Heart in the center of the Strip. Attach your Hearts.
~Use two Glue Dots to attach each Ribbon Knot as shown. If your ribbon does not want to stay in the position you want just add a Glue Dot close to the knot and lay the Ribbon where you want it.
~Add your Words Label with Stampin’ Dimensionals.
~Put a Iridescent Rhinestone on each Heart.
Your Beautiful Hearts and Bows Valentine Card is finished.
