Here is a brief introduction to The NEW Stampin’ Positioner by Stampin’ Up! Learn the basics of how to use it. If you join my Team between Feb 3 and 28th, 2026 it will be included as part of your Business Supplies with your Starter Kit.
This Video is less than 16-1/2 minutes.
INCLUDED:
~Instructions
~Base Plate: 8″ x 10″.
~Large Plate: 7-1/2″ x 10″. Printed with 1/4″ Black Grid Lines.
~Small Plate: 2″ x 8″. Printed with 1/4″ Black Grid Lines.
~Two Magnets
INSTRUCTION DETAILS:
~Come with printed details in English, French, German, and (I think) Dutch.
~Four pictures showing how to use your Large Plate.
~Three pictures showing how to use your Small Plate.
BASE PLATE DETAILS:
~This Base Plate is totally flat. You can lay any size paper on it, including 12×12 papers. Larger papers will hang flat off the edges
~5/8″ Rulers along the top and right side in both inches and metric. These are debossed (sunk down) into the plastic so they don’t leave bumps.
~The Rulers start with 0 in the center. This will help when positioning your cardstock.
~Triangle marking in the center to use for what I call the Wreath Technique. Look for a video later showing this Technique.
~Posts for your Small Plate so you can do Repeat Stamping.
~Posts for your Large Plate.
~Springs for your Large Plate to make Stamp Positioning easier.
~Felt like fabric on the back.
~Grid Paper is 6-3/4″ x 8-3/4″. Grid Paper is sold separately.
LARGE PLATE DETAILS:
~Holes to fit on the Spring Posts at the top of the Base Plate.
~Springs in the bottom corners.
~1/4″ Black Grid Marks cover 5-3/4″ x 9-1/2″. These will help you position your Stamps straight.
~Printed Stampin’ Up! logo to help you quickly attach your Positioner. This logo is on the opposite side as your Post Holes.
SMALL PLATE DETAILS:
~Holes to fit on the extra posts at the top. You can choose any of these posts to attach your Small Plate to.
~Four Springs.
~There is a bit of wiggle allowed. Make sure you don’t hold onto the plate with one hand while pressing down with the other. This may make your Stamping crooked.
~Black printed 1/4″ Grid Marks covering 1-1/2″ x 5-1/2″
MAGNET DETAILS:
~”Handles” to easily remove from your Positioner.
~These magnets are covered with plastic, so they should not break.
~Round Magnets covered in plastic with Handles to easily pick up.
~Put the Magnet part that shows the Circle Magnet onto your paper.
~Have the mostly Black Circle with the thin Silver Magnet showing at the top when you put the Magnet onto your Paper. This will let the Handle be slightly raised above your cardstock for easy removal.
You now know the basic info about The NEW Stampin’ Positioner.
