Happy Halloween Pumpkin Treat Holder

Need a last minute Halloween Treat Holder?  Make this Halloween Pumpkin Treat Holder in just a few minutes.  Put your treats in a cello bag and attach it inside this Jack O’Lantern.
Halloween Pumpkin Treat HolderSUPPLIES:
Card Stock:  Tangelo Twist
Basic Black
Garden Green
Punches:  2-1/2″ Circle #120906 (for smile)
Tree #135859 (for eyes and nose)  You can also just hand cut the eyes and nose.
Banner #133519 (for stem)
Bird Builder #117191 (for Vine)
1/8″ Handheld Circle #134365
Other:  Metallic Gold Baker’s Twine #132975
4″ x 6″ Cellophane Bags #102757
Tombow Glue

INSTRUCTIONS:
1.  Cut your Tangelo Twist card stock at 3-1/4″ x 7″ and 3-1/4″ x 9″.  Score the 7″ piece at 2″ on one end.  Score the 9″ piece at 2″ on both ends.  Fold Score Lines.  Glue together a 2″ section of each piece together to form the bottom of your Treat Holder.  Fold the top 2″ tab over to the Back.  Hold the top pieces together and punch two 1/8″ holes through all layers for your Baker’s Twine.  Now thread your Baker’s Twine through.  You have the hard part done.
2.  Punch:
~three Festive Trees from Basic Black card stock.  Trim two down to size for the eyes and the last one even shorter for the nose.
~half of a  2-1/2″ Circle from Basic Black card stock.  Cut notches as desired for teeth.
~Banner  from Garden Green for stem
~Leaves from the Bird Builder punch for the vine from Garden Green card stock.
3.  Glue all your punched pieces on.
4.  Fill your Cellophane Bag with Treats and close.  Use Fast Fuse or Tear & Tape to hold the bag inside your Jack O’Lantern.

Happy Halloween!
Nendy Kerr

Tagged , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *